Filter
Top Products
Appendix F: Miscellaneous
FĆ24
AWG2021 User Manual
Factory Settings
When Reset to Factory is selected from the UTILITY Misc menu, this
instrument’s parameters are reset to the values they had at the factory. Table F-1
lists these factory settings.
Table FĆ1: Factory Settings
Setup Menu
Clock Frequency 100.00 MHz
Clock Source Internal
CH1 Operation Normal
Filter Through
Amplitude 1.000 V
Offset 0.000 V
Display Graphics
MODE Menu
Operating mode Cont
Triggered Slope Positive
Gated Polarity Positive
Level 1.4 V
Impedance 1 MW
Sync Start (Sync is End when the operation mode is Cont.)
LOAD/SAVE Menu
Device Disk
Auto Load Off
UTILITY Menu
Misc Display... Brightness 70%
Misc Display... Catalog Order Name1
Misc Display... Data Time Off
Misc Hardcopy... Format BMP
Misc Hardcopy... Port Disk
Diag/Cal Diagnostics All
Diag/Cal Calibrations All
FG Menu
Function waveform Selection Sine
Frequency 2.500 MHz