Filter
Top Products
EDIT Menu
AWG2021 User Manual
3 Ć203
3. Press Draw Area in the sub-menu and select Mag (magnitude) or Phase
(phase).
4. Press the VALUE button on the front panel. Using the general purpose knob,
move the point cursor to the location of the new point. Pressing the VALUE
button will toggle the direction of movement from horizontal (X) to vertical
(Y) and vice-versa. The location of the point cursor is displayed in the upper
right-hand corner of the screen in X (frequency) and Y (magnitude or phase)
coordinates.
5. When you have placed the point cursor at the desired location, select Add
Draw Point from the sub-menu to add a point at that location.
It is possible to add points outside the area defined by the vertical bar
cursors. However, such points will be ignored when Execute is pressed.
NOTE. It is not possible to draw more than one point at the same location on the
horizontal axis. If you attempt to do this, a message will appear asking you to
confirm that you want to change the level of the existing point. Press O.K. or
Cancel in response to this message.
6. Repeat Steps 4 and 5 to add several new points.
7. To delete a point that you have added with Add Draw Point, move the point
cursor to that point and select Delete Draw Point. The point will be deleted.
If you press Delete Draw Point several times in succession, the points that
you have added will be deleted in sequence starting with that nearest to the
point cursor.
8. Select Execute from the sub-menu. The points that you have added will be
connected to the magnitude or phase on the left and right vertical bar cursors.
Figure 3 -145 shows an example of a magnitude drawn between the vertical
bar cursors.