Filter
Top Products
EDIT Menu
3 Ć128
AWG2021 User Manual
6. Select Line from the sub-menu. Turning the general purpose knob, select
DATA11 for which you want to set the pattern.
7. Select Register Config... from the sub-menu.
8. Press the CURSOR button on the front panel to select Register Length.
9. Using the general purpose knob, set the register length to 15.
10. Select Clear All Taps in the sub-menu to delete all taps.
11. Select Set All Regs in the sub-menu to set all registers to 1.
12. Press the CURSOR button on the front panel to select Register Position.
13. Using the general purpose knob, set the Register Position to 13.
14. Press the VALUE button on the front panel to set the tap.
15. Press the CURSOR button on the front panel to select Point/Step.
16. Using the general purpose knob, set Point/Step to 1.
17. Press the CURSOR button on the front panel to select Code.
18. Using the general purpose knob, select NRZ.
19. Select O.K. from the sub-menu.
20. Select Execute from the sub-menu. The timing display shown below will
appear.
21. Select Go Back from the sub-menu.