Filter
Top Products
EDIT Menu
3 Ć126
AWG2021 User Manual
code series) bit strings. M series bit strings are combined with several
different kinds of tap arrangements. The tap arrangement will change each
time the Set Maximal Linear Taps button is pressed.
H Setting Register Values. Use Set All Regs in the sub-menu to set all register
values to 1.
Sample Settings for Register Values and Taps
Set simply set register and tap values as follows:
Register Length: 3
Register Value: 101
Use Set Maximal Linear Taps to set taps
Figure 3 -91 shows the output for the above settings. This output will be the
maximum length code series.
110
111110000
1 period
Output
Figure 3 Ć91: Sample Settings for Register Values and Taps
Point/Step. Point/Step is used to set how many points make up each data bit. The
data after Code conversion will be one item of bit data. For example, when
NRZI is selected for Code and Point/Step is set to 2, each data bit will consist
of 4 points.
Code. This command selects the code system used when data pattern strings are
output. The user defined code enables you to define a custom conversion table.
For a detailed description of each code, see “Pattern Codes” in Appendix F.
User defined Code Config... .The following process is used to execute a user-de-
fined code conversion.