Filter
Top Products
EDIT Menu
3 Ć90
AWG2021 User Manual
Figure 3 Ć69: Compare... Item Selected
10. Press the Set Result to button in the sub-menu to select MARKER1.
This item is used to set where the results of comparison will be displayed.
11. If you would like to apply hysteresis to the reference waveform, select
Hysteresis and enter a value. If hysteresis is not necessary, this item should
be set to 0.
Hysteresis comparison uses a higher and lower signal level than the Source
signal level; the degree is determined by the value set with the Hysteresis
item.
12. Select Execute from the sub-menu.
Comparison Without Hysteresis — The left part of Figure 3 -70 shows a
comparison of a triangular wave for Waveform2 and a square wave for
Waveform1, with the results output to the Waveform2 MARKER display area.
The figure on the right has been provided as an aid to understanding this process.
Comparison is only performed for the section of Waveform2 between the
vertical bar cursors (in other words, from point 125 to point 875). Data outside
this range is preserved as it was before comparison. The figure on the right
shows the default marker set at point 0 remains “1.”