Filter
Top Products
EDIT Menu
3 Ć102
AWG2021 User Manual
Figure 3 Ć78: Count Up Pattern Display
The following parameters can be set:
Step The number of points for each data item. This value can be
set to 1 – 10.
Max The maximum value for the data. This value can be set
anywhere between (Min value + 1) and 4095.
Min The minimum value for the data. This value can be set
anywhere between 0 and (Max value – 1).
H Count Down. Data is created sequentially, decreasing from the initial value
designated for Max to the minimum value designated for Min. When the
minimum value is exceeded, the value returns to the maximum value and
countdown begins again. The values for Step, Max and Min can be set in
the same manner as with Count Up.
H Gray Code. A data pattern is created in which the difference between
adjacent data is only 1 bit. When the 4096 items of 12-bit data end, the data
repeats from the beginning. In the example shown in Figure 3 -79, the
waveform point size has been set to 4096 and Step has been set to 1. Only
the Step parameter is set for the Gray Code pattern option.