Filter
Top Products
AWG2021 User Manual
3 Ć229
MODE Menu
General Description
Press the MODE button in the MENU column to display the MODE menu. The
MODE menu is used to set the operating mode of the waveform output with the
conditions set in the SETUP menu.
This menu enables you to perform the following functions:
H Setting waveform or sequence waveform output trigger mode
H Waveform Advance and Autostep functions that display the waveform
sequence with the trigger
H Determine the timing with which the sync signals are generated
The trigger or gate signal can be generated with external signals from the
TRIGGER INPUT connector or by pressing the front panel MANUAL button.
When the instrument receives the trigger or gate signal, the “Waiting for
Trigger” display in the status area of the CRT display changes to “Running”
and the waveform or sequence is output. When output stops, the status area
display returns to the original “Waiting for Trigger”.
The screen displays a contents list for each channel. This list shows the
waveform/sequence file selected with the SETUP menu and the contents of the
file. The display is almost the same for all operating modes.
The explanations that follow are for an instrument with the Option 02, CH2
output. An instrument without the Option 02 has only the CH1 display.