Filter
Top Products
EDIT Menu
3 Ć40
AWG2021 User Manual
Figure 3 Ć21: Adding Noise to the Sine Wave
NOTE. Portions of the waveform that protrude outside the editing area when the
other waveform is added will be clipped.
Procedure 3: Multiplying Waveforms. In this example, you will multiply the sine
wave you created in Procedure 1 by another sine wave with a different frequency.
The procedure starts from where you left off in Procedure 2.
1. Select Undo from the bottom menu. This will eliminate the noise waveform
added in Step 2.
2. Select Type from the side menu. Turn the general purpose knob or press the
Type button in the side menu and select Mul Sine.
3. Select Cycle from the side menu. Using the numeric keys or the general
purpose knob, set the number of cycles for the sine wave to 30.