Filter
Top Products
EDIT Menu
AWG2021 User Manual
3 Ć45
There are no sub-menus associated with these commands; when they are
selected, the copy or paste operation is performed instantly. Marker signals
associated with that waveform data are also subjected to the copy and paste
operations. Pasting data into a waveform will naturally increase the number of
points in that waveform.
1. Specify the waveform to be copied with the left and right vertical bar
cursors. Select Copy to Buffer from the displayed side menu.
When Copy to Buffer is selected, the waveform data between the vertical
bar cursors (including the left and right vertical bar cursor data) is copied
into the paste buffer. Marker signals associated with that waveform data are
also subjected to the copy operation. This operation does not affect the
display on the CRT.
2. Press the front panel CURSOR button.
3. Use the general purpose knob to specify the position to paste the data with
whichever of the vertical bar cursors is active.
The data is pasted directly before the active vertical bar cursor. However,
when the cursor is at the end of the waveform, the data is inserted directly
after the cursor.
4. Select Paste from Buffer from the side menu.
Figure 3 -25 shows an example of a waveform before and after additional data is
pasted into that waveform.
AfterBefore
Figure 3 Ć25: Pasting Waveforms