Filter
Top Products
EDIT Menu
3 Ć38
AWG2021 User Manual
Setting the Parameters for Function Waveforms. The following parameters can be
set for each type of function waveform designated with the Type command.
Note, however, that only Amplitude and Offset can be set for a Noise
waveform, while only Offset can be set for a DC waveform.
Cycle 0.1 to 100,000 (in 0.1 increments)
Frequency 2 Hz to f / 5 (f = Clock frequency set with Setting menu
item
Amplitude ±2.0005 (if set to a negative number, the wave form will
haveinverse polarity)
Offset –1.0000 to +1.0005
Procedure 1: Creating a Sine Wave. In this example, you will replace the data
between the vertical bar cursors with a sine wave. The procedure begins at the
initial menu level.
1. Select New Waveform from the side menu in the initial menu.
2. Select Standard Waveform from the bottom menu.
3. Check to make sure that the left and right vertical bar cursors are all the way
to the left and right, respectively, to encompass the entire editing area. If they
are not, use the general purpose knob to set them in this manner.
4. Press the Type button in the side menu and select Sine.
5. Select Cycle from the side menu. Use the numeric keys or the general
purpose knob to set the number of cycles for the sine wave to 2.
6. Select Amplitude from the side menu. Use the numeric keys or the general
purpose knob to set the p
-
p amplitude for the sine wave to 1.
7. Select Execute from the side menu.
When Execute is selected, the sine waveform is created between the vertical
bar cursors with the set parameters. See Figure 3 -20.