Filter
Top Products
Appendix C: Performance Verification
AWG2021 User Manual
CĆ15
c. Select the file:
H Push SETUP!Waveform Sequence, if necessary, to select a
waveform file for CH1. Waveform Sequence toggles between the
CH1 files (upper list) and the CH2 files (lower list).
H Turn the general purpose knob to highlight the MODE.WFM file.
H Push ENTER to select the file.
3. Turn on the AWG2021 CH1 output: Push the CH1 button so that the LED
above the CH1 output connector is on.
4. Check burst count: Push the AWG2021 MANUAL TRIGGER button and
check that when the button is pushed, the oscilloscope displays three cycles
of sine wave.
5. End procedure: Disconnect the oscilloscope.
Electrical
Characteristic Checked
Operating mode, Gated, on pageĂBĆ1.
Equipment Required Three 50ĂW coaxial cables, a 50 W precision termination, a
function generator, and an oscilloscope.
Prerequisites The AWG2021 meets the prerequisites listed on page CĆ5.
1. Install test hookup and set test equipment controls:
a. Hook up the oscilloscope: Connect the AWG2021 CH1 output connector
through the coaxial cable to the CH1 vertical input connector on the
oscilloscope.
b. Hook up the function generator: Connect the function generator output
to both the AWG2021 TRIGGER INPUT and the oscilloscope CH2
input through a coaxial cable, precision termination, and a dual input
coupler (see Figure C-6).
Check Gated Mode