Filter
Top Products
MODE Menu
3 Ć234
AWG2021 User Manual
Impedance
STOP
The Slope, Level and Impedance items are used to set the trigger conditions for
the external trigger signal.
Figure 3 -162 shows the output waveform for an external trigger signal.
External Trigger Signal
Output Signal
Figure 3 Ć162: Output Waveform for External Trigger Signal in Triggered Mode
Use Gated mode to control waveform or sequence output with a gate signal. The
gate signal depends on the gate source. It can be generated from the external gate
signal applied to the TRIGGER INPUT connector or while the front panel
MANUAL button is pressed.
While the front panel MANUAL button is pressed, the specified waveform or
sequence is output. When you let the MANUAL button go, the waveform output
stops. When you press the MANUAL button again, the waveform or sequence
output resumes from the level where it left off. While you are pressing the
MANUAL button, if you press any other button, the instrument goes back to the
mode before the MANUAL button was pressed.
The specified waveform or sequence waveform is output while a valid external
gate signal is being received through the TRIGGER INPUT connector. After
output stops, at the next external gate signal, the waveform or sequence resumes
from the waveform level where it left off.
When Gated is selected, the following items will be displayed in the side menu:
Polarity
Level
Gated Mode