Filter
Top Products
MODE Menu
3 Ć236
AWG2021 User Manual
External Trigger Signal
Output Signal
Burst Quantity
Figure 3 Ć164: Output Waveform for External Trigger Signal in Burst Mode
Setting Burst Count. Burst Count sets the number of repetitions of the waveform
or sequence that are output with the trigger signal. This count can be from 1 to
65 535.
Use Waveform Advance mode to output a series of specified waveforms, in
order, with a new trigger initiating the advance to output the next waveform.
Thus, in this mode, the repetition count defined for each waveform in the
sequence file (defined with the sequence editor) is ignored. Each waveform is
output continuously until the next trigger is received. When the last waveform
defined is reached, this mode returns to the first waveform again.
NOTE. Waveforms are output in line with the output parameters designated in the
SETUP menu for that sequence file.
When Waveform Advance is selected, the following items will be displayed in
the side menu:
Slope
Level
Impedance
STOP
The Slope, Level and Impedance items are used to set the trigger conditions for
the external trigger signal.
When this instrument goes into Waveform Advance mode, it waits for a trigger
to be generated. This trigger can be generated from the external trigger signal
Waveform Advance Mode