Filter
Top Products
Aspire Wireless
Aspire Software Manual Features ◆ 95
Out-of-Range
When a Aspire Wireless phone receives an incoming call and the phone is considered out-of-range
(Program 20-22-05 timer expires), what the system does with the call and what the caller hears
depends on system programming.
● Extension callers will hear a lock-out tone and may see “Out of Range” on their display.
● DISA callers will following the programming set in Program 25-04-01 : VRS/DISA Transfer
Ring Group With No Answer/Busy.
● DID and DIL callers hear ringing and can then be transferred to voice mail or to another
extension based on the settings in Program 15-15-05 and 15-15-06.
● Tie line callers will hear the lock-out tone.
The Aspire Wireless requires the following hardware:
● 4-Port Interface PCB (P/N 0891090), 8-Port Interface PCB (P/N 0891091), or 12-Port Inter-
face PCB (P/N 0891092)
● Handset with Battery (P/N 780004)
● Base Station (P/N 780136)
● Charging Cradle (P/N 780137)
Optional Equipment:
● Leather Cover w/Clip for Aspire Wireless (DECT) Handset (P/N 780148)
● Repeater (P/N 780138)
● AC Adapter (P/N 780139)
● Battery (NMh) (P/N 780140)
● Handset Belt Clip (P/N 780141)
● Repeater Programming Kit (P/N 780142)
● Service Tool Kit (P/N 780143)
● Deployment Tool (P/N 780144)
● External Antenna w/Cable for Repeater (P/N 780145)
Prior to deleting an Aspire Wireless (DECT) phone from the system using Program 91-07-01 :
DECT Subscription - Delete, make sure the DSIU PCB is installed in the system. If the DSIU is
removed when Program 91-07-01 is run, the system will retain the DECT setting. This will prevent
the Aspire Wireless phone(s) from being registered in the system again.
Programs Available for Gain Adjustment
With software 2.63 or higher, you can adjust the gain of the Aspire Wireless handsets using Pro-
gram 15-15-07 and 15-15-08.
Register/Unregister Handset by Service Code
The Aspire Wireless telephones can be registered or unregistered at a display keyset using a service
code. Note the following conditions when using this feature:
● As this feature uses extension numbers and not port number, it is not possible to have the sys-
tem select an available port as when using Program 91-06-01.
● This feature only supports the wild card subscription method. It is not possible to specify the
IPEI number.
● The wait timer for terminal registration is fixed at 600 seconds.
● This feature can only be used from a display keyset. Digital single line telephones and i-Series
phones cannot be used.
● This option is not available for Networked systems.