Filter
Top Products
Conference
246 ◆ Features Aspire Software Manual
To Transfer a Call Into a Conference:
1. While on a call, press HOLD.
2. Dial the Transfer to Conference service code (default=124).
If the telephone doesn’t have the proper COS, a warning tone is sent. After the user
hangs up, the system will automatically place a Callback to the extension.
The display shows "Transfer to Conf. ICM Dial".
3. Dial the extension number or press a DSS key of a telephone within a Conference call.
If an error tone is heard, Barge In is not enabled for the extension and the call will not
go through. Retrieve the call by pressing the flashing line or CALL key or hang up and the
call will recall the extension.
When the call is transferred into the Conference, an intrusion tone is heard by all par-
ties in the conference, depending on the entries in Program 20-13-17 and Program 80-01,
and all display keysets will show the joined party.
To cancel the transfer, press the flashing line or CALL key to retrieve the call.
4. Hang up.
Break Up the Conference But Retain the Trunk Calls
1. While on an active Conference call, press HOLD.
2. Select the line or loop key of the caller you wish to talk to.
Any intercom calls which were involved in the Conference will be disconnected.
Dropping a Party From the Conference
1. While on an active Conference call, press the line/loop key of the party to retain. This action
will retain any intercom calls involved in the Conference.
OR
With a Super Display Telephone, press the one-touch key of the party to be dropped.
With a Super Display keyset, the trunk name (for outgoing calls) or Caller ID (for
incoming calls, if available) will be displayed in the one-touch key display area for up to
10 calls.