Filter
Top Products
Transfer
Aspire Software Manual Features ◆ 589
Programming
➻
11-10-06 : Service Code Setup (for System Administrator) - Setting the Automatic For-
warding for Each Trunk Line
If the default service code (833) for enabling the Automatic Tandem Trunking feature is not
acceptable, change the code as required.
➻ 11-12-58 : Service Code Setup (for Service Access) - Transfer into Conference
Use this program to assign the code users dial to Transfer a call into a Conference call. This
code is normally 124.
➻ 11-15-09 : Service Code Setup Administrative (for Special Access) - Transfer to Trunk
Ring Group Code
When a call is transferred using this service code, it's transferred to the ring group destination
for that incoming trunk. For example, trunk 2 is in Ring Group 4. When the call is transferred
using this service code, the trunk will ring all extensions programmed for Ring Group 4 or ring
the External Paging Group for Ring Group 4, depending on how the system is programmed.
➻ 14-01-26 : Basic Trunk Data Setup - Automatic Trunk to Trunk Transfer Mode
For each trunk, enable (1) or disable (0) the Step Transfer function when using the Automatic
Trunk-to-Trunk Transfer feature. If this option is disabled, the call will be forwarded to the
first specified destination only.
➻ 15-02-05 : Multi-Line Telephone Basic Data Setup - Transfer Key Operation Mode
Use this option to set the operating mode of the extension’s CONF key. The keys can be for
Call Transfer (0), Serial Calling (1) or Flash (2). When selecting the Flash option, refer also to
Program 81-01-14.
➻ 15-02-24 : Multi-Line Telephone Basic Data Setup, Conference Key Mode
This option allows an extension’s CONF key to be programmed for Conference or for Trans-
fer. When set for Transfer (1), the user places a call on hold, dials the extension to which it
should be transferred, the presses the CONF key. The call is then transferred. When set for
Conference (0), with an active call, the user presses the CONF key, places a second call, then
presses the CONF key twice. All the calls are then connected.
➻ 15-07-01 : Programmable Function Keys
Extension users may want a function keys programmed for Transfer (code 06).
➻ 20-02-01 : System Options for Multi-Line Telephones - Retrieve the Line After Transfer
Enable (1) or disable (0) an extension’s ability to answer a call after it’s been transferred, but
before it’s answered.
➻ 20-03-01 : System Options for Single Line Telephones - SLT Call Waiting Answer Mode
For a busy single line (500/2500 type) telephones, set the mode used to answer a camped-on
trunk call:
● 0 = Press and release hookswitch to pick up waiting call
● 1 = Press and release hookswitch and dial Service Code 894 to answer waiting call
➻ 24-02-02 : System Options for Transfer - MOH or Ringback on Transferred Calls
Use these options to enable (0) or disable (1) MOH on Transfer. If enabled (0), a transferred
caller hears Music on Hold while their call rings the destination extension. If disabled (1), a
transferred caller hears ringback while their call rings the destination extension. For this
option to work with voice mail, the transferred call must be an unscreened transfer.
➻ 20-06-01 : Class of Service for Extensions
Assign a Class Of Service (1-15) to extensions.
➻ 20-11-06 : Class of Service Options (Hold/Transfer Service) - Unscreened Transfer
In an extension’s Class of Service, enable (1) or disable (0) the extension’s ability to use
Unscreened Transfer.