Filter
Top Products
Conference
Aspire Software Manual Features ◆ 245
To drop an outside call from the Conference:
1. Press HOLD to place the Conference call on Hold.
2. Hang up.
The lines involved in the Conference will ring back separately to the phone.
3. Answer and disconnect the unwanted outside call.
4. To re-establish the Conference, answer the remaining call pressing CONF after each call is
answered. Press CONF twice when all calls have been answered.
To exit a Conference without affecting the other parties:
K
eyset
1. Hang up.
If you press Hold while on a call with two outside callers, the outside callers hear
Music on Hold.
If Program 20-11-21 is enabled, hanging up with multiple outside calls connected will
create a Tandem Trunk call.
Single Line Set
1. Hang up.
If you are not permitted to use Tandem Trunking, outside callers may hear Music on
Hold.
To Barge In to Conference Call:
1. Pick up the handset or press SPK and dial the service code (810=default).
If the telephone doesn’t have the proper COS, a warning tone is sent. After the user
hangs up, the system will automatically place a Callback to the extension.
2. Dial the extension number or press a DSS key of a telephone within a Conference call.
When a new call is added to the conference, an intrusion tone is heard by all parties in
the Conference, depending on system programming, and all display keysets show the
joined party. If a Conference is not possible:
- the extension user will hear a warning tone
- the DISA user will be rerouted to the defined ring group
OR
- the tie line user will hear a busy tone.
OR
Not available for DISA or tie line trunks:
1. Dial the extension number of the internal party.
2. Dial the single digit service code.
Instead of the single digit service code, the service code 810 can also be dialed at this
point.