Filter
Top Products
Maintenance
Aspire Software Manual Features ◆ 397
System Information
The system can print a report of the PCBs installed, the port assignments, and the port types. This
information is sent to the port defined in Program 90-13. This report includes:
● The version of system software
● PCB names
● Slot condition (working, blocked)
● Port assignment
● Port classification
Sample Report:
Reloading Customer Databases
When reloading a customer database, the system must be reset (either using Program 90-08 or
power down/power up) before all uploaded programming will take affect.
After uploading the programming, reset the system and wait a few minutes for the system to reset
completely before accessing any lines or special system features. Otherwise, some unusual LED
indications may be experienced.
Conditions
(A.) Aspire S and Aspire Customer Databases Not Interchangeable
Due to database differences, saved customer databases are not interchangeable between the
Aspire S and Aspire systems.
The PCPro will prevent the upload of an incorrect database by disabling the Upload button
when the system database does not match the system to which you are connected.
However, when using Program 90-04 : Load Data, the system will not be able to prevent an
incorrect upload. It is important to make sure you only load data saved from an Aspire S to an
Aspire S system and data saved from an Aspire to an Aspire system.
Default Setting
Enabled.
<< System Information >> 06/16/2003 13:57
slot location type assign port condition note
----------------------------------------------------------------------------------------------------
1 1-1 ESIU 1- 16 Running *******- -------- Connect:*
2 1-2 COIU 1- 4 Running
3 1-3 SLIU 17- 24 Running
4 1-4 VMSU 25- 28 Running
5 1-5 -none- -none-
6 1-6 -none- -none-
7 1-7 -none- -none-
8 1-8 -none- -none-
9 2-1 -none- -none-
10 2-2 -none- -none-
11 2-3 -none- -none-
12 2-4 -none- -none-
13 2-5 -none- -none-
14 2-6 -none- -none-
15 2-7 -none- -none-
16 2-8 -none- -none-