Filter
Top Products
Program 15 : Extension, Basic Setup
15-03 : Single Line Telephone Basic Data Setup
908 ◆ Programming Aspire Software Manual
03 Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call setup.
Enter 0 to have the port ignore DTMF tones after
the initial call setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
0 = Normal
1 = Special
0
04 Flashing
Enables/disables Flash for single line (500/2500
type) telephones.
0 = Disable
1 = Enable
1
05 External Reverse
Not Used in U.S. - Do Not Change Default Entry
as DTMF issues may arise with voice mail.
0 = Disable
1 = Enable
0
06 Extension Reverse
Not Used in U.S. - Do Not Change Default Entry
as DTMF issues may arise with voice mail.
0 = Disable
1 = Enable
0
07 Enabled on hook when holding (SLT) 0 = Disable
1 = Enable
1
08 Answer on hook when holding (SLT) 0 = Disable
1 = Enable
1 11-12-46
09 Caller ID Function - For External Module
Enable (1) or disable (0) the Caller ID FSK signal
for an external Caller ID module or a 3rd party
vendor phone with Caller ID display. With the
Caller ID Sender Queueing feature, set this option
to “1” for the extension.
Important:
If voice mail is used, this setting must
be disabled or the system integration codes for
disconnect will be incorrect.
Note: With some earlier software, if a 2500 set
(no Caller ID) is installed, this must be set to “0”
or else incoming callers will not have a talkpath.
0 = Disable
1 = Enable
0
10 Caller ID Name
Determine if an extension user’s phone should
display the Caller ID name.
0 = Disable
1 = Enable
1 14-02-10
20-09-02
11 Caller ID Type
This option allows you to select either FSK or
DTMF as the Caller ID type to be received by a
single line telephone.
0 = FSK
1 = DTMF
0 14-02-16
12 - Not Available -
13 MW Signal Type
For analog single line telephones which provide a
display, when a user leaves a Message Waiting for
a SLT which has a display, this option is used to
determine whether the SLT user will see a MW
LED indication or if the Caller ID will be used to
display the call.
0 = Lamp
Indication
1 = Caller ID
Indication
0