Filter
Top Products
Program 90 : Maintenance Program
90-10 : System Alarm Setup
Aspire Software Manual Programming ◆ 1517
5 0 0 Download Error Download may have failed
because the PCB is blocked
(disabled) or the sub-pro-
gram does not exist on the
system flash card.
After unblocking the PCB, if
RECover message is received
in the alarm report, it is cor-
rected. If not, then replace the
system flash card.
6 0 0 PCB Blocking
7 1 (MAJ) 0 Power Failure System power supply may
be defective or commercial
power is off.
Check the system AC switch,
fuse and AC outlet. If still faulty,
replace the power supply.
8 1 (MAJ) 0 RAM Backup Battery
Error
RAM backup battery on the
CPRU PCB is unplugged or
defective.
Check the battery connector. If
it is connected correctly, then
replace the battery.
9 0 0 Blocking (No default
setting)
Failure may have occurred
because:
• Terminal blocking
detected.
• Terminal is unplugged.
• Wire is disconnected.
• DSTU card is defective.
Check the terminal wiring and
reconnect properly. Then
unplug and plug in the PCB. If
RECover message is received
in the alarm report, it is correct.
If not, replace the PCB and/or
terminal.
10 0 0 ISDN Link Error
11 0 0 CTI Link Error
12 0 0 ACD MIS Link Error
13 0 0 -- Not Used in U.S. --
14 0 0 NTCPU-LAN Link
Error
15 0 0 Networking Keep
Alive Error
: : : :
30 2 (MIN) 0 SMDR Buffer Full The SMDR buffer is full. Check the printer for the
SMDR.
: : : :
35 0 0 CS Blocking -- Not Used in U.S. --
36 0 0 CS Error Information 1 -- Not Used in U.S. --
37 0 0 CS Transmission Error -- Not Used in U.S. --
38 0 0 CSIU Dch Error -- Not Used in U.S. --
39 0 0 CSIU Transmission
Error
-- Not Used in U.S. --
Alarm Type Report Note
Is Used To
Advise of . . .
Action