Filter
Top Products
Program 15 : Extension, Basic Setup
15-02 : Multi-Line Telephone Basic Data Setup
Aspire Software Manual Programming ◆ 905
24 Conference Key Mode
This option allows an extension’s
CONF key to be programmed for Con-
ference or for Transfer. When set for
Transfer (1), the user places a call on
hold, dials the extension to which it
should be transferred, the presses the
CONF key. The call is then trans-
ferred. When set for Conference (0),
with an active call, the user presses the
CONF key, places a second call, then
presses the CONF key twice. All the
calls are then connected. In order for
Cordless II and Cordless Lite II users
to use a Flash key, this option must be
set to “1” for those extensions.
0 = Conference
1 = Transfer
0 15-02-05
26 MSG Key Operation Mode
Determine whether an extension’s
MSG key should function as a Mes-
sage key or Voice Mail key. If set as a
Message key, the user will be able to
press the key to call the voice mail
only when they have new messages.
0 = Message Key
1 = Voice Mail Key
0
27 Volume of Handset
This option determines whether a key-
set’s handset volume will change back
to the system default (0) or whether it
will be retained at the user’s setting (1)
after hanging up the handset.
0 = Revert to Default Volume
1 = Retain User’s Setting
1
28 Message Waiting LED Color
This option allows you to select
whether the Message Wait LED
located at the top of the keyset will
flash green (0) or red (1) when a Mes-
sage Wait indication is flashing. By
default, this option is set to "1" (red).
Note that if this LED is also used for
voice mail indications (no Program-
mable Function Key programmed for
voice mail), if there are both voice
mail messages and Message Wait indi-
cations, the color set for Message Wait
will override the color used for voice
mail indications (red).
0 = Flashes Green
1 = Flashes Red
1
29 ISDN Back Tone
This program option can be used to
adjust the PB Back Tone level when
calling an ISDN line.
1-63
(-15.5 to +15.5 db in 0.5 dB
steps)
32
Item
No.
Item Input Data Default
Related
Program