Filter
Top Products
Distinctive Ringing, Tones and Flash Patterns
Aspire Software Manual Features ◆ 319
Programming
➻
15-02-02 : Multi-Line Telephone Basic Data Setup - Trunk Ring Tone
From the range specified in Program 22-03, select the keyset extension’s trunk ring tone.
➻ 15-02-03 : Multi-Line Telephone Basic Data Setup - Extension Ring Tone (Pitch)
Select the extension’s intercom ring tone.
➻ 22-03-01 : Trunk Ring Tone Range
Set the ring tone range (1-4) for each trunk.
➻ 80-01-01 : Service Tone Setup
Customize the system’s basic tones and system service tones.
➻ 82-01-01 : Incoming Ring Tone
Customize the trunk ring tones (i.e., the tones a user hears when a trunk rings an extension). If
desired, change the Intercom and External Alarm Sensor ring tones.
➻ 82-03-01 : DSS Console LED Pattern Setup
Customize the DSS and Hotline key flash patterns.
Related Features
Multiple Directory Numbers/Call Coverage
Set up ring tones for Multiple Directory Numbers and Call Coverage keys.
Single Line Telephones
Single line telephone users cannot listen to or change the pitch of their phone’s incoming ring.
Operation
To listen to the incoming ring choices (keyset only):
1. Press idle CALL key.
2. Dial 811.
3. Dial 1 to check ringing for Intercom calls.
OR
Dial 2 to check ringing for trunk calls.
4. For Intercom calls, select the pitch you want to check (1-8).
OR
For trunk calls, select the pitch (1-8) and the tone (1-4) you want to check.
Refer to Table 1-7 for the four Trunk Ring Tone Ranges and the selections within each
range.
5. Go back to step 4 to listen to additional choices or press SPK to hang up.
To change the pitch of your incoming ring (keyset only):
1. Press idle CALL key.
2. Dial 820.
3. Dial 1 to change ringing for Intercom calls.
OR
Dial 2 to change ringing for trunk calls.
4. Select the pitch (1-8).
5. Press SPK to hang up.