Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
1304 ◆ Programming Aspire Software Manual
44-02 : Dial Analysis Table for ARS/F-Route Access
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction
Table for selecting ARS/F-Route.
Input Data
Level:
Aspire S Aspire M/L/XL
IN • Available. • Available.
Dial Analysis Table Number 1-120
Item No. Item Input Data Default
01 Dial
Set the number of digits to be analyzed by the
system for ARS routing.
Up to 8 digits
(Use line key 1 for a “Don’t Care”
digit, @)
No
setting
02 Service Type
• Service Type 1 (Extension number)
The number goes to an extension after delet-
ing the front digit(s).
Additional data
Assign the digit(s) to be deleted on top of the
number for extension number usage. There
must be at least one digit deleted.
• Service Type 2 (ARS/F-Route)
The number is controlled by ARS/F-Route
table.
Additional data
If the ARS/F-Route Time Schedule is not
used, assign the ARS/F-Route table number
for Program 44-05.
If the ARS/F-Route Time Schedule is used,
assign the ARS/F-Route selection number for
Program 44-04.
• Service Type 3 (Dial Extension Analyze
Table)
The total length of the number exceeds more
than 8 digits.
Additional data
Assign the Dial Extension Analysis Table
number to be used in Program 44-03.
0=No setting
1=Extension Call
2=ARS/F-Route Table
3=Dial Extension Analyze Table
0