Filter
Top Products
ISDN Compatibility
Aspire Software Manual Features ◆ 377
➻ 15-01-04 : Basic Extension Data Setup - ISDN Caller ID
If both Program 15-01-04 and 10-03-05 are enabled (1), the system includes Caller ID in the
Setup message as “Presentation Allowed”. If these options are disabled (0), it will be “Presen-
tation Restricted”.
➻ 15-02-29 : Multi-Line Telephone Basic Data Setup, ISDN Back Tone
This program option can be used to adjust the PB Back Tone level when calling an ISDN line.
(Entries: 1-63 [-15.5 to +15.5 db in 0.5 dB steps], Default Setting: 32)
➻ 15-07-01 : Programmable Function Keys
Assign a function key for Caller ID Block for ISDN (63) if required.
➻ 20-06-01 : Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
➻ 20-08-13 : Class of Service Options (Outgoing Call Service) - ISDN CLIP
Determine if the ISDN calling line identity presentation and screening indicators are to be
allowed (1) or disabled (0).
➻ 20-08-14 : Class of Service Options (Outgoing Call Service) - ISDN Call Address
Information
Determine whether the sub-address should be sent for outoing ISDN calls (0=disabled,
1=enabled).
➻ 20-09-02 : Class of Service Options (Incoming Call Service) - Caller ID Display
In an extension’s Class of Service, enable (1) or disable (0) the extension’s ability to display
incoming Caller ID name/number information.
➻ 20-09-03 : Class of Service Options (Incoming Call Service) - Sub Address Identification
In an extension’s Class of Service, enable (1) or disable (0) the extension’s ability to display
the Caller Sub-Address.
➻ 20-11-11 : Class of Service Options (Hold/Transfer Service) - Automatic On Hook Transfer
In an extension’s Class of Service, enable (1) or disable (0) the extension’s ability to use Auto-
matic On Hook Transfer. If enabled, user must press HOLD and dial the extension number to
Transfer the call. If disabled, a user must have a Transfer Programmable Function Key. Used
with 2 B-Channel Transfer.
➻ 20-11-14 : Class of Service Options (Hold/Transfer Service) - Trunk-to-Trunk Transfer
For each Class of Service, allow (0) or deny (1) Trunk-to-Trunk Transfer (Default Setting: 1).
Required for 2 B-Channel Transfer.
➻ 20-11-21 : Class of Service Options (Hold/Transfer Service) - Restriction for Tandem
Trunking on Hang Up
Allow (0) or deny (1) an extension user’s ability to set up a tandem call automatically when
they hang up. By default, this option is allowed (0). Required for 2 B-Channel Transfer.
➻ 20-13-23 : Class of Service Options (Supplementary Service) - Display the Reason for
Transfer
Enable (1) or disable (0) an extension’s ability to display the reason (Call Forward, Busy, No
Answer or DND) a VRS, DID, DISA, or ISDN call is being transferred to their extension.
➻ 20-08-13 : Class of Service Options (Outgoing Call Service) - ISDN CLIP
Determine if the ISDN calling line identity presentation and screening indicators are to be
allowed (0=disabled, 1=enabled).
➻ 20-25-14 : ISDN Options - Operation Mode When Second T303 Timer Expires
This option can be used to determine whether or not a release message is sent when the sec-
ond T303 timer expires. (Entries: 0=normal/off, 1=send release message, Default Setting: 0)