Filter
Top Products
Program 14 : Trunk, Basic Setup
14-02 : Analog Trunk Data Setup
Aspire Software Manual Programming ◆ 879
07 DP to DTMF Conversion Options
Determine how a user can convert a Dial Pulse (DP)
call to a DTMF call. For each trunk, set the type of
DP to DTMF conversion required. There are three
conversion options: Automatic (0), Automatic and
Manual (1), or Manual (2).
A
utomatic:
DP to DTMF conversion occurs automatically if the
extension user waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs automatically if the
extension user waits more than 10 seconds before
dialing the next digit. In addition, the user can dial #
to switch a DP trunk to DTMF dialing.
Manual:
User can dial # to switch a DP trunk to DTMF dial-
ing
0 = Automatic
1 = Automatic and Manual
2 = Manual
2 21-01-03
08 Answering condition 0 = Polarity reversing
1 = Polarity reversing
or timer
1 21-01-03
09 Busy Tone Detection
If this option is enabled (1) for a trunk, if there is no
DSP resource available, the Multiple Trunk Confer-
ence cannot be completed.
0 = disable
1 = enable
0
10 Caller ID
Enable or disable a trunk’s ability to receive Caller
ID information.
0 = disable
1 = enable
0
11 Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the system’s ability
to skip over a trunk if dial tone is not detected. This
option pertains to calls placed using Loop Keys,
Speed Dial, ARS, Last Number Redial or Save
Number dialed. It does not pertain to line key or
Direct Trunk Access calls.
0 = disable
1 = enable
0
12 Detect Network Disconnect Signal
- Not Used in U.S. -
0 = disable
1 = enable
1
13 Trunk-to-Trunk Limitation
- Not Used in U.S. -
0 = disable
1 = enable
0
14 Loop Start/Ground Start 0 = Loop Start
1 = Ground Start
0
16 Caller ID Type
Select the type of Caller ID signal from an analog
trunk - FSK or DTMF.
0 = FSK
1 = DTMF
0 15-03-11
Item
No.
Item Input Data Default
Related
Program