Filter
Top Products
Station Message Detail Recording
536 ◆ Features Aspire Software Manual
➻ 35-02-18 : SMDR Output Options - Caller ID Name Output Method
Select whether to display up to 16 characters of the Caller ID Name on the same line as the
call record (0) or if a line feed should be added and up to 24 characters of the Caller ID Name
will be displayed on the following line (1). If the line feed option is selected, the Caller ID
Name will be displayed on the next line as : NEXT "Caller ID Name". The default entry for
this option is "0".
This setting will work regardless of the setting in Program 35-02-15.
Note: With this option set to "1", if your communications program (such as HyperTerminal)
has the line wrap option enabled in the ASCII setup, an additional line break may appear
above the Caller ID name line.
➻ 35-03-01 : SMDR Port Assignment for Trunk Group
Assign the SMDR port for each trunk group. For each Trunk Group, select the SMDR port to
which the incoming SMDR information should be sent.
➪ Aspire S Trunk Groups: 1-8, SMDR Ports 1-2
➪ Aspire Trunk Groups: 1-100, SMDR Ports 1-8
➻ 35-04-01 : SMDR Port Assignment for Department Groups
Assign the SMDR port for each Department Group. For each Department Group, select the
SMDR port to which the outgoing SMDR information should be sent.
➪ Aspire S: Department Groups 1-8, SMDR Ports 1-2
➪ Aspire: Department Groups 1-64, SMDR Ports 1-8
➻ 80-05-01 : Date Format for SMDR and System Reports
Set the date format for SMDR (0=American, 1=Japanese or 2=European).
Related Features
PBX Compatibility
To use the PBX Call Reporting option, program system for behind PBX operation.
Networking
Extensions across a network are not included in SMDR.
Traffic Reports
Traffic Management Reports and SMDR should not use the same CTA port.
Operation
Once installed and programmed, SMDR operation is automatic.