Filter
Top Products
VoIP
656 ◆ Features Aspire Software Manual
Programming - Using the Aspire DHCP
➻ 10-13-01 : In-DHCP Server Setup - DHCP Server Mode
Enable (1) the system’s ability to use the built-in DHCP server. The system must be reset in
order for the change to take effect.
➻ 10-13-02 : In-DHCP Server Setup - Lease Time
Enter the lease time of the IP address to a client (default: 0 days, 0 hours, 30 minutes). The
system must be reset in order for the change to take effect.
➻ 10-13-04 : In-DHCP Server Setup - Number of Networks
Select the number of networks in use on the system (default: 0, entries: 0=Single Network,
1=Divide Same Network). The system must be reset in order for the change to take effect.
➻ 10-14-01 : Managed Network Setup - Scope 1
Set the range of IP addresses available to be used by the DHCP server for Scope 1 (default:
Minimum = 172.16.0.100, Maximum = 172.16.5.254, Scopes 1-10).
➻ 10-15-01 : Client Information Setup
Set the IP and MAC addresses for each client (up to 10) when the DHCP server needs to
assign a fixed IP address to clients.
➻ 10-16-01 : Option Information Setup - Router
Set the router address for the DHCP server to the client.
➻ 10-16-02 : Option Information Setup - DNS Server
If required, set the DNS server address for the DHCP server to the client.
➻ 10-16-03 : Option Information Setup - TFTP Server
Set the TFTP server address for the DHCP server to the client.
➻ 10-16-04 : Option Information Setup - DRS
Set the NTCPU’s IP address for the DHCP server to the client.
➻ 84-04-01 : VOIPU PCB DHCP Server Mode Setup
Enable (1) the use of DHCP for the VOIPU PCB.
➻ 84-05-01 : VOIPU IP Address Setup - IP Address
For each VOIPU PCB, enter the IP address for the VOIPU PCB (default: slot 1=172.16.0.20,
slot 2 = 172.16.0.21, etc.). The IP address should be increased according to the number of
VOIPU PCBs. This entry becomes invalid if Program 84-04 is set to "1" (DHCP enabled).