Filter
Top Products
Multiple Directory Numbers / Call Coverage
Aspire Software Manual Features ◆ 423
Programming
➻
11-04-01 : Virtual Extension Numbering
Assign extension numbers to Multiple Directory Numbers.
➪ Aspire S Virtual Extension Ports: 1-24
➪ Aspire Virtual Extension Ports: 1-256
➻ 11-07-01 : Department Group Pilot Numbers
In order to queue multiple calls to a busy virtual extension key, assign a pilot number to each
Department Group set up in Program 16-02. The pilot number is the number users dial for the
Department Group when transferring a call. If the extensions in the group are busy, the call
will be placed in queue until an extension is available.
➻ 14-05-01 : Trunk Groups
Assign trunks to trunk groups.
➪ Aspire S Trunk Groups: 1-8
➪ Aspire Trunk Groups: 1-100
➻ 14-06-01 : Trunk Group Routing
Set up an outbound routing table for trunk groups assigned in Program 14-05.
➪ Aspire S Trunk Group Routes: 1-8
➪ Aspire Trunk Group Routes: 1-100
➻ 15-01-01 : Basic Extension Data Setup - Extension Name
Assign names to virtual extensions.
➻ 15-01-02 : Basic Extension Data Setup - Outgoing Trunk Line Preference
Set this option to determine if an extension user seizes Prime Line when they lift the handset
(0=disable, 1=enable).
➻ 15-01-05 : Basic Extension Data Setup - Restriction for Outgoing Disable on Incoming
Line
Enable (1) or disable (0) supervised dial detection for an extension.
➻ 15-02-21 : Multi-Line Telephone Basic Data Setup, Virtual Extension Access Mode
Determine whether an extension’s Virtual Extension/Call Coverage Key should be used as a
DSS key to the extension and for receiving calls (0), answering incoming calls and ability to
place outgoing ICM or CO calls (1), or just receiving incoming calls (2). If the key is to be
used for outgoing calls, the extension number of the key must be a real extension or virtual
extension number. When the extension number of the key is a real extension number, when
the key is pressed, the real extension cannot be used.
➻ 15-07-01 : Programmable Function Keys
Assign function keys for Multiple Directory Numbers (code *03 + extension number).
➻ 15-08-01 : Incoming Virtual Extension Ring Tone Setup
Assign a ring tone (0-4) to each extension port and virtual extension port assigned to a Multi-
ple Directory Number key. If ringing is enabled for the key in Program 15-09, the key rings
with the tone set in this program. Each port can have one of four different rings.
➻ 15-09-01 : Virtual Extension Ring Assignment
Individually program an extension’s Multiple Directory Number function keys to either ring
(1) or not ring (0).
➻ 15-10-01 : Incoming Virtual Extension Ring Tone Order Setup
Set the priority (1-4) for the Multiple Directory Number Ring Tones set in Program 15-08.
When Multiple Directory Number calls ring an extension simultaneously, the tone with the
highest priority (e.g., 1) rings. The other keys just flash.
➻ 15-11-01 : Virtual Extension Delayed Ring Assignment
Individually program an extension’s Multiple Directory Number keys for Delayed Ringing (1)
or Immediate Ringing (0). Also see Program 20-04-03 below.