Filter
Top Products
Caller ID
190 ◆ Features Aspire Software Manual
5. Press the ONET Soft Key. The display shows:
6. Press the One-Touch key in which the number is to be stored or dial 1-9, 0. If you press
HOLD, the next available One-Touch key will be used. The display shows:
If all One-Touch keys are used, the display shows “TABLE IS FULL”.
7. Press HOLD. The display shows:
8. Enter the name to be associated with the stored number.
9. Press HOLD. The display shows:
10. Press SPK.
The telephone returns to an idle condition.
Store to ONE TOUCH
ENTER BIN
KEY ##:
xxxxxxxxxxxxx
KEY ##
-
With Software 2.05+:
Key for Entering Names
When entering names in the procedures below, refer to this chart. Names can be up to
12 digits long. For prior software or when using i-Series phones, refer to the charts in
the Name Storing feature (page 432).
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
→→
→→
←←
←←
Á À Â Ã Ç É Ê ì ó
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, d-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü α ε θ
* Enter characters:
* + , - . / : ; < = > ? π ∑ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed - ex: TOM).
Pressing # again = Space. (In system programming mode, use the right arrow soft key
instead to accept and/or add a space.)
CONF Clear the character entry one character at a time.
CLEAR Clear all the entries from the point of the flashing cursor and to the right.
KEY PROG ONE TOUCH