Filter
Top Products
Central Office Calls, Answering
Aspire Software Manual Features ◆ 215
➻ 22-18-03 : Private Call Assignment Setup - Incoming Ring Pattern
Determine the ring pattern to be used ( 0 = normal pattern, 1-4 = tone pattern 1-4, 5-9 = scale
pattern 1-5) for a “Private” Caller ID call. The definition of the tone pattern is the same as Pro-
gram 22-03.
➻ 23-03-01 : Universal Answer/Auto Answer
For Universal Answer, assign trunk routes set in Program 14-06 to extensions. An extension user
can use Universal Answer to answer a call if the ringing trunk is in its assigned route.
➪ Aspire S Trunk Group Routes: 1-8
➪ Aspire Trunk Group Routes: 1-100
➻ 40-10-06 : Voice Announcement Service Option - Set VRS Message for Private Call
Refuse
Use this option to assign the VRS message number to be played when Private Call Refuse is
enabled for a call with “Private” Caller ID information (0 = Does not play message, 1-49 =
VRS message number to play).
➻ 40-10-07 : Voice Announcement Service Option - Set VRS Message for Caller ID Refuse
This item assigns the VRS message number to be used as the Caller ID Refuse message when
the Caller ID number matches the entry in Program 22-16 (0 = Does not play message, 1-49 =
VRS message number to play).
➻ 81-09-01 : COIU CODEC Filter Data Setup
The system will use the settings in this program when Program 81-07-01 : CODEC Filter
Setup for Analog Trunk Ports is set to "4 - Specified Data". These values should not be
changed from their default settings unless directed by NEC’s Technical Service department.
The side tone of the COIU is adjusted using all 16 values, however, special software is
required in order to compute these values. The setting is not proportional to the gain level. To
change these values, contact NEC’s Technical Service department for assistance.
➻ 82-01-01 : Incoming Ring Tone
Customize the ring tones within each Ring Tone Range. Assign Ring Tone Ranges to trunks in
22-03. Trunks ring extensions according to the Ring Tone Range selected in 22-03 and the
user settings made with Service Code 820.
➻ 82-08-01 : Sidetone Volume Setup
Use this program to adjust of the keyset side tone volume. There are two levels, based on
whether the connected trunk is a digital trunk or analog trunk.
➻ 82-09-01 : SLIU CODEC Filter Data Setup
The system will use the settings in the new Program 82-09 : SLIU CODEC Filter Data
Setup when Program 82-07-01 : CODEC Filter Setup for Analog Station Ports is set to "4
- Specified Data". These values should not be changed from their default settings unless
directed by NEC’s Technical Service department.
The side tone of the COIU is adjusted using all 16 values, however, special software is
required in order to compute these values. The setting is not proportional to the gain level. To
change these values, contact NEC’s Technical Service department for assistance.