Filter
Top Products
Transfer
Aspire Software Manual Features ◆ 591
➻ 21-01-03 : System Options for Outgoing Calls - Trunk Interdigit Time (External)
Program how long an extension must wait before using the Barge In feature can be used on a
call (this timer waits until this timer expires before putting a call in a talk state). This timer
also affects Voice Over.
➻ 22-04-01 : Incoming Extension Ring Group Assignment
Assign extensions to ring groups.
➻ 22-05-01 : Incoming Trunk Ring Group Assignment
Define a trunk’s ring group. When transferring a DID or trunk call to the trunk’s defined ring
group, the trunk will then ring the defined extensions for the ring group.
➻ 22-08-01 : DIL/IRG No Answer Destination
Assign the DIL No Answer Ring Group (1-103) to which an unanswered call should overflow.
➻ 24-02-01 : System Options for Transfer - Busy Transfer
Prevent (0) or allow (1) extensions to transfer calls to busy extensions. If disabled, calls trans-
ferred to busy extensions recall immediately.
➻ 24-02-03 : System Options for Transfer - Delayed Call Forwarding Time
If activated at an extension, Delayed Call Forwarding occurs after this interval (0-64800 sec-
onds). This also sets how long a Transferred call waits at an extension forwarded to Voice
Mail before routing to the called extension’s mailbox.
➻ 24-02-04 : System Options for Transfer - Transfer Recall Time
Set the Transfer Recall Time (0-64800 seconds). An unanswered transferred call recalls to the
extension that initially transferred it after this interval. This interval also sets how long a
transferred call camps-on to a busy extension.
➻ 24-02-05 : System Options for Transfer - Transfer to Busy Department Group Recall
Timer
After a trunk is unscreen transferred to a busy Department Group, this timer will start. If the
call is not answered, it will recall the originator (0-64800 seconds).
➻ 24-02-11 : System Options for Transfer - No Answer Timer for Step Transfer
Define the length of time (0-64800 seconds) the system will wait before Step Transferring a
no-answer call to the next destination.
➻ 24-02-12 : System Options for Transfer - No Answer Timer for Automatic Trunk-to-
Trunk Transfer
Define the length of time (0-64800 seconds) the system will wait before Automatic Trunk-to-
Trunk Transfer occurs for a no-answer call.
➻ 24-04-01 : Automatic Trunk-to-Trunk Transfer Target Setup
Define the Abbreviated Dialing number bin(s) which are to be used as the destination of the
Automatic Trunk-to-Trunk Transfer.
➻ 25-06-02 : VRS/DISA One-Digit Code Attendant Setup
Define the digit to be used by a VRS caller which will allow their call to be transferred to the
external page.
➻ 31-05-01 : Universal Night Answer/Ring Over Page
For each trunk which should ring the external page, set the External Page zone (1-9) to allow
ringing (1).
➻ 81-01-14 : COIU Initial Data Setup - Flash (Hooking 1)
Set the flash duration for analog trunk calls (1-255 in 16ms steps).