Filter
Top Products
Program 44 : ARS/F-Route Setup
44-05 : ARS/F-Route Table
1310 ◆ Programming Aspire Software Manual
44-05 : ARS/F-Route Table
Description
Use Program 44-05 : ARS/F-Route Table to set the ARS/F-Route table. There are 4 kinds of
order. If the higher priority trunk groups are busy, the next order group will be used. If a lower pri-
ority route is selected, the caller may be notified with a beep tone.
Input Data
Level:
Aspire S Aspire M/L/XL
IN • Available. • Available.
ARS/F-Route Table Number 1-500
Priority Number 1-4
Item No. Item Input Data Default
01 Trunk Group Number
Select the trunk group number to be used for the
outgoing ARS call.
0-100, 101-150, 255
(0 = No setting, 101-150 =
Networking,
255 = Extension Call)
0
02 Delete Digits
Enter the number of digits to be deleted from the
dialed number.
0-255
(255 = Delete all)
0
03 Additional Dial Number Table
Enter the table number (defined in Program
44-06) for additional digits to be dialed.
0-1000 0
04 Beep Tone
Select whether or not a beep is heard if a lower
priority trunk group is used to dial out.
0 = off
1 = on
0
05 Gain Table Number for Internal Calls
Select the gain table number to be used for the
internal call (defined in Program 44-07).
0-500
(0 = No setting)
0
06 Gain Table Number for Tandem Connections
Select the gain table number to be used for the
tandem call (defined in Program 44-07).
0-500
(0 = No setting)
0
07 ARS Class of Service
Select the ARS Class of Service to be used for
the table. An extension’s ARS COS is determined
in Program 26-04-01.
0-16 0