Filter
Top Products
Toll Restriction
Aspire Software Manual Features ◆ 573
Additional Default Entries For Common Permit Code Table
Additional entries have been added to the default Common Permit Code Table. The default setting
is now as follows:
Tie Line Toll Restriction Enhanced
With older software, the system only provided the use of Program 34-08 to determine the toll
restriction a tie line trunk would follow. This table only allowed 20 entries.
With software 2.65 or higher, a new program is available, 34-01-05 : E&M Tie Line Basic Setup -
System Toll Restriction. If this option is set to ’0’, the system will follow the setting in 21-05-13 :
Toll Restriction Class - Restriction of Tie Line Calls to determine whether or not the toll restric-
tion setting in Program 34-08 is to be followed. If this option is set to ’1’, the system will follow the
system toll restriction settings defined in Program 21-05-01 through 21-05-13.
Conditions
(A.) If a Toll Restriction Class has the same entries in both a permit and restriction table, the sys-
tem does not restrict the call.
(B.) Toll Call Digit counting may prevent users from taking advantage of long distance automated
services like ACD and automated Technical Service.
(C.) Toll Restriction is applied when accessing ARS.
(D.) If Program 21-01-10 is programmed with an entry other than “0”, a call will not have a talk
path unless the user dials at least the number of digits entered in this option when placing an
out going call. This means that an entry of 4 or higher in this program will cause a problem
when dialing 911. Since it is only a 3-digit number, the call will not have a talk path, prevent-
ing the emergency dispatcher from hearing the caller. It is recommended that this option be
kept at its default setting of “0” to prevent any problems with dialing 911.
Default Setting
Disabled.
• Table 1: 911 • Table 4: 1822 (new) • Table 7: 1855 (new)
• Table 2: 1800 • Table 5: 1833 (new) • Table 8: 1866 (new)
• Table 3: 1888 • Table 6: 1844 (new) • Table 9: 1877 (new)