Filter
Top Products
Voice Mail
Aspire Software Manual Features ◆ 609
Unlike the Aspire S, the IntraMail ports in the Aspire M must be defined in system programming.
Notes:
● The VRS cannot be used when the IntraMail CompactFlash card is installed.
● An external voice mail and the IntraMail cannot work simultaneously.
● The Aspire Mail (VMSU/FMSU PCBs) and IntraMail cannot work simultaneously.
● The IntraMail will not work automatically as with the Aspire S. Programs must be defined for
port usage.
● When the DSPDB is used for IntraMail, the daughter board does not provide any additional
DSP resources (for DTMF Receivers, Caller ID Receivers, or Call Progress Tone Detection).
● The IntraMail does not work with the Enhanced NTCPU (PAL-B). If switching from an
Enhanced NTCPU PAL chip to a Standard or Feature Upgrade for the IntraMail feature, the
system must be cold started due to the port number differences or the IntraMail will not
function correctly.
● PVMU stops when IntraMail is used. (The PVMU is not available in the U.S.)
IntraMail: Ability to Select Voice Mail Port Selected for Message Notification/MW
Lamps
The Aspire S can select an available voice mail port which can be used the Message Notification or
MW Lamp update routines.
IntraMail: External Transfer Available
The software provides the ability for the IntraMail to perform an external transfer. This allows the
IntraMail to route an incoming Automated Attendant call out of the Aspire system on a new trunk
based on an Abbreviated Dial number stored in a Dial Action Table.
IntraMail: Soft Key With Security Code Programming
The software provides a soft key when programming the security code. This soft key allows a user
to select OK/CANCEL following an entry of a new code.
IntraMail: Internal Message Notification Timer Lengthened
When Message Notification places a call out, the system will wait up to 30 seconds for ringback,
reorder, or busy tone from the trunk. If detected, notification call out processing begins normally. If
not detected, the system abandons the call and decrements the Ring No Answer (RNA) count. In
older software versions, the system would wait 15 seconds. This could cause notification callbacks
to be inadvertently abandoned.