Filter
Top Products
Selectable Display Messaging
510 ◆ Features Aspire Software Manual
Programming
➻
11-11-14 : Service Code Setup (for Setup/Entry Operation) - Text Message Setting
Define the service code to be used when setting a text message.
➻ 15-07-01 : Programmable Function Keys
Assign a function key for Call Forwarding (Device) (code 17) or Text Message (code 18). The Call
Forwarding Device key allows the user to select a message each time they activate the feature,
while the Text Message key automatically selects the message used when programming the key.
➻ 15-07-01 : Programmable Function Keys
Using the Text Message Setup key (18 + message number), a user can easily set the Selectable
Display Messaging feature with the preprogrammed message number.
➻ 20-01-02 : System Options - Text Message Mode
Select whether and intercom caller should hear busy (1) or ring through (0) for extensions
which have Selectable Display Messaging set. Note: Any extensions previously set with
Selectable Display Messaging must cancel the feature and reactivate in order for a change in
this option to take affect.
➻ 20-02-07 : System Options for Multi-Line Telephones - Time and Date Display Mode
Set the System Time and Date display mode. The time that displays in Selectable Display
Messages follows this setting.
➻ 20-06-01 : Class of Service for Extensions
Assign a Class Of Service (1-15) to an extension.
➻ 20-13-19 : Class of Service Options (Supplementary Service) - Selectable Display Messaging
In an extension’s Class of Service, enable (1) or disable (0) an extension’s ability to use
Selectable Display Messaging.
➻ 20-16-01 : Selectable Display Messages
Program the Selectable Display Messages (1-20). Refer to the chart below for character entry.
Use this keypad digit . . . When you want to. . .
1 Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | } > <
2 Enter characters A-C, a-c, 2.
3 Enter characters D-F, a-f, 3.
4 Enter characters G-I, g-i, 4.
5 Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7 Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0 Enter characters:
0 ! “ # $ % & <space> ( )
* Enter characters:
* + , - . / : ; < = > ?
# # = Accepts an entry (only required if two letters on the
same key are needed - ex: STA)
CONF Clear the character entry one character at a time.
FLASH Clear all the entries from the point of the flashing cursor
and to the right.