Filter
Top Products
Voice Mail
616 ◆ Features Aspire Software Manual
➻ 47-02-02 : IntraMail Station Mailbox Options -Mailbox Number
For each mailbox enabled in Program 47-02-01, assign an extension number. Programs 47-02-
01 and 47-02-02 are required in order for an extension user to be able to access their voice
mail mailbox.
➻ 47-01-02- 47-01-15
47-02-01 - 47-01-14
47-03-01 - 47-03-03
47-04-01 - 47-04-04
47-05-01 - 47-05-03
47-06-01 - 47-06-12
47-07-01 - 47-07-02
47-08-01 - 47-08-04
47-09-01 - 47-09-03
47-10-01 - 47-10-01
47-11-01 - 47-11-04
47-12-01 - 47-12-08
47-13-01
Refer to the Aspire IntraMail System Guide, P/N 0893240, for complete programming details.
➻ 80-03-01 : DTMF Tone Receiver Setup
80-04-01 : Call Progress Tone Detector Setup
Use these programs to set the criteria for DTMF dial, ringback and busy tones.
➻ 84-06-10 : VOIPU Setup - DTMF Behavior
With IP Networking, set this option to “1” (RFC2833) in addition to changing Program 84-
12-31 in order for DTMF tones to be acknowledged by the voice mail.
➻ 84-12-31 : H.323 Phone CODEC Information Setup - DTMF Relay Mode
With IP Networking, set this option to “2” (out-of-band) in addition to changing Program 84-
06-10 in order for DTMF tones to be acknowledged by the voice mail.
Related Features
Barge In
Conversation Record will not work for monitored calls.
Call Forwarding, Fixed
Fixed Call Forwarding can be used to transfer a user’s unanswered calls to their voice mail.
Call Forwarding does not have to be programmed manually by every user.
Caller ID
Caller ID information will be passed from the Voice Mail to an extension for pre-answer dis-
play on an unscreened transfer from Voice Mail.
Central Office Calls, Placing
Off-premise notification and external extensions require access to outside lines.
Data Communications
With APA/APR modules installed, make sure to setup up other required programming.
Direct Inward Line
To have the Voice Mail Automated Attendant answer a trunk, program the trunk as a DIL to a
Voice Mail port.
Hold
When the voice mail places a call on hold, it uses Group Hold. Any line appearances for the
trunk will show the hold flash rate, however, users will not be able to pick up these calls (a
busy signal will be heard).