Filter
Top Products
VoIP
654 ◆ Features Aspire Software Manual
13. The phone needs be restarted for the new settings to take effect. Press Select key to restart the
phone, press Del/Cancel to return to the previous menu or Menu to return to standby mode
without restarting the phone.
If there is an error in saving, “Cannot Save” will be displayed for 1 second.
14. Repeat Steps 1-6.
15. Use the ▲ and ▼ keys to move to Subnet Mask.
16. Press the Select key to read the value. The next screen displayed prompts you to change the
value if needed.
If DHCP is enabled, subnet mask will be read only and user cannot change the subnet
mask address.
17. Press the Select key to change the Subnet Mask. Enter the correct Subnet Mask and press the
Select key.
For on-site LANs this is the entry in Program 10-12-02. When phones are off-site
(remote LAN) , these settings are dependant on the remote LAN settings - not the phone
system settings.
The format of the Subnet Mask is: xxx.xxx.xxx.xxx (use the * key to enter the decimal
between the numbers). Allowed entries for each set of three numbers are 0-255.
If the entered subnet mask is not valid, “Invalid Input” will be displayed for 1 second.
Press the Cancel/Del key to return to the previous screen without making any changes.
18. The phone needs be restarted for the new settings to take effect. Press Select key to restart the
phone, press Del/Cancel to return to the previous menu or Menu to return to standby mode
without restarting the phone.
If there is an error in saving, “Cannot Save” will be displayed for 1 second.
19. Repeat Steps 1-6.
20. Use the
▲ and ▼ keys to move to Default Gateway.
21. Press the Select key to read the value. The next screen displayed prompts you to change the
value if needed.
If DHCP is enabled, default gateway will be read only and user cannot change the address.
22. Press the Select key to change the Default Gateway. Enter the correct Default Gateway and
press the Select key.
For on-site LANs this is the entry in Program 10-12-03. When phones are off-site
(remote LAN) , these settings are dependant on the remote LAN settings - not the phone
system settings.
The format of the Default Gateway is: xxx.xxx.xxx.xxx (use the * key to enter the deci-
mal between the numbers). Allowed entries for each set of three numbers are 0-255.
If the entered subnet mask is not valid, “Invalid Input” will be displayed for 1 second.
Press the Cancel/Del key to return to the previous screen without making any changes.
23. The phone needs be restarted for the new settings to take effect. Press Select key to restart the
phone, press Del/Cancel to return to the previous menu or Menu to return to standby mode
without restarting the phone.
If there is an error in saving, “Cannot Save” will be displayed for 1 second.
24. Repeat Steps 1-6.
25. Use the ▲ and ▼ keys to move to VLAN Enable/Disable. Press the Select key.