Filter
Top Products
VoIP
652 ◆ Features Aspire Software Manual
2. Press 1 to enter the DHCP mode. If not flashing, press "1" to disable the DHCP mode. Press
the Soft Key “OK”.
The flashing item is the current selection.
3. Press 2 to enter the Primary DRS (Device Registration Server). Enter the IP address used in
Program 10-12-01 (default: 172.16.0.10). The * key is used to move to the next set of 3 digits
(example: 172*16*0*10). Press the Soft Key “OK”.
The Soft Key “BK” backs up a character to correct an entry.
4. Press 4 to enter the IP address for the phone. The IP address must be unique to each phone but
the range is dependent upon system programming (example: IP Keyset 1 = 172.16.0.11, IP
Keyset 2 = 172.16.0.12, etc.). The * key is used to move to the next set of 3 digits (example:
172*16*0*10). Press the Soft Key “OK”.
For on-site LANs, the IP address must be unique to each phone but the range is depen-
dent upon system programming (example: IP Phone 1 = 172.16.0.11, IP Phone 2 =
172.16.0.12, etc.). When phones are off-site (remote LAN) , these settings are dependant
on the remote LAN settings - not the phone system settings.
The Soft Key “BK” backs up a character to correct an entry.
5. Press 5 to enter the Default Gateway address.
For on-site LANs this is the entry in Program 10-12-03. When phones are off-site
(remote LAN) , these settings are dependant on the remote LAN settings - not the phone
system settings.
6. Press 6 to enter the Subnet Mask.
For on-site LANs this is the entry in Program 10-12-02. When phones are off-site
(remote LAN) , these settings are dependant on the remote LAN settings - not the phone
system settings.
7. Press the Soft Key “SAVE” to save the entries and return the phone to an idle condition.
Pressing CANCEL instead will ignore the changes made and return the keyset to an
idle condition.
In this program entry mode, items "3. DTS Address Secondary" and "7. DNS" can be set as
required by the customer but are not required for the feature to function. Item "8. VLAN" is dis-
cussed below. Item "9. System Information" displays the entries and does not allow any changes.