Filter
Top Products
VoIP
Aspire Software Manual Features ◆ 689
VoIP Phones
When connecting an VoIP phone, the MAC address (ID) is automatically registered in Program 15-
05-02. If the registration in Program 15-05-02 is made manually, prior to connecting the phone,
when the phone is connected, it will use the extension number assigned. The MAC address is
printed on the barcode label on the bottom of the phone or adapter. It is a 12-digit alphanumeric
number, ranging from 0-9 and A-F.
Aspire keysets with an IP adapter do not use Program 80-01 : Service Tone Setup entries. The
tones, instead, are provided by the IP adapter. When a Door Box chime rings an Aspire keyset with
IP adapter, the system activates the chimes using a ring command. Because of this, if the volume is
adjusted while the door chime is sounding, the ringing volume of the Aspire keyset with IP adapter
will be adjusted.
In addition, Music on Hold is also provided by the IP adapter. The settings in Program 10-04 :
Music on Hold Setup are ignored except to determine whether or not music should be provided. If
10-04-02 is set to "0", no music on hold will be heard. If 10-04-02 is set to "1" or "2", music will be
provided by the IP adapter, but there is only one music selection.
Programming
➻ 15-05-02 : IP Phone Terminal Basic Data Setup - NGT Fixed Port Assignment
If a specific extension number is to be assigned to an Aspire keyset with an IP adapter, the
MAC Address of the IP adapter must be set for the extension. For the extension number which
has the IP adapter connected, enter the MAC Address of the IP adapter. This MAC Address is
printed on the IP adapter label (default: 00-00-00-00-00-00). If this is not set, the system will
automatically assign the next available extension number.
Use line keys 1-6 to enter letters A-F (key 1=A, key 2=B, etc.)
Use caution when entering in the MAC Address as the system will allow duplicate
entries to be made. If there are two duplicate entries, the lowest matching extension will be
assigned to the MAC Address.
Aspire IP and Aspire Keyset with IP Adapter
There are two program levels available for individual phone programming - the User Menu and the
Maintenance Menu. Each program mode is accessed differently.
Accessing the User Menu
1. On the Aspire IPhone or an Aspire keyset with an IP Adapter, enter the phone’s program mode
by pressing HOLD CONF * #. The following shows the menu items available in the phone’s
programming.
This enters the IP User Menu program mode to select the settings for the individual phone.
Default
1. DHCP Mode Enabled
Disable
Enable
2. DRS Address Primary 0.0.0.0
3. DRS Address Secondary 0.0.0.0
4. IP Address 0.0.0.0
5. Default Gateway 0.0.0.0
6. Subnet Mask 0.0.0.0