Filter
Top Products
Program 10 : System Configuration Setup
10-03 : PCB Setup
730 ◆ Programming Aspire Software Manual
Note 1. The start port number of a BRI line is displayed. Two logic ports are automatically
assigned to a BRI line.
Note 2. Each timer value of Layer3 are set up for every type of Program 81-06 (T-Bus) and Pro-
gram 82-06 (S-Bus).
11 Networking System Number (NW
mode only)
0-50 0
12 - Not Currently Used - 0
13 - Not Currently Used - 0
14 Service Protocol for S-Point 0 = Keypad Facility
1 = Specified Protocol for Aspire System
0
15 Alert Tone When S-Bus Terminal
Calls Busy Extension
This option determines for S-Bus ter-
minals what a user on an S-Bus termi-
nal will hear when a busy extension is
called. If this option is set to "0", the
user will hear an alert tone. If this
option is set to "1", the user will be
disconnected.
0 = Alert Tone
1 = Disconnected
0
17 Ringback Tone to Telco Now Possi-
ble with BRI Trunks
This option can be used to determine
whether or not the system sends ring-
back tone to the telco.
0 = Disable
1 = Enable
0
18 Type of Number
Use this option to define the ISDN
numbering plan to allow the calling
party information to be passed to some
telcos. Note that with software
4.08-4.0W, Program 99-01-32 was
used instead.
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
3
19 Numbering Plan Identification
passed to some telcos. Note that with
software 4.08-4.0W, Program
99-01-33 was used instead.
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
1