Filter
Top Products
Message Waiting
414 ◆ Features Aspire Software Manual
Conditions
(A.) Reminder messages require a DSP daughter board for VRS messages.
(B.) Analog ports from APA or APR adapters do not provide Message Waiting lamping.
Default Setting
Enabled.
Programming
➻
11-10-16 : Service Code Setup (for System Administrator) - Leaving Message Waiting
11-11-09 : Service Code Setup (for Setup/Entry Operation) - Answer Message Waiting
11-11-10 : Service Code Setup (for Setup/Entry Operation) - Cancel All Messages Waiting
11-11-11 : Service Code Setup (for Setup/Entry Operation) - Cancel Message Waiting
11-12-37 : Service Code Setup (for Service Access) - Common Canceling Service Code
11-16-07 : Single Digit Service Code Setup - Message Waiting
If necessary, customize the service codes used for these features.
➻ 15-02-28 : Multi-Line Telephone Basic Data Setup, Message Wait LED
This option allows you to select whether the Message Wait LED located at the top of the key-
set will flash green (0) or red (1) when a Message Wait indication is flashing. Note that if this
LED is also used for voice mail indications (no Programmable Function Key programmed for
voice mail), if there are both voice mail messages and Message Wait indications, the color set
for Message Wait will override the color used for voice mail indications (red).
➻ 15-03-13 : Single Line Telephone Basic Data Setup - MW Signal Type
An option is available for analog single line telephones which provide a display. When a user
leaves a Message Waiting for a SLT which has a display, this option is used to determine
whether the SLT user will see a MW LED indication (0) or if the Caller ID will be used to dis-
play the call (1).
➻ 15-07-01 : Programmable Function Keys
Assign a function key for Message Waiting (code 38).
➻ 20-06-01 : Class of Service for Extensions
Assign a Class Of Service (1-15) to an extension.
➻ 20-13-07 : Class of Service Options (Supplementary Service) - Message Waiting
In an extension’s Class of Service, enable (1) or disable (0) an extension’s ability to leave
Messages Waiting.
➻ 24-02-05 : System Options for Transfer - Message Wait Ring Interval Timer
For SLTs without message waiting lamps, this timer determines the amount of time between
intermittent ringing. If this timer is set to '0' then the system rings once.
➻ 80-01-01 : Service Tone Setup - Message Wait Dial Tone
If the default tone is not acceptable for the Message Wait Dial Tone, a new tone can be assigned.