Filter
Top Products
Direct Inward Dialing (DID)
284 ◆ Features Aspire Software Manual
Programming
➻
10-03-01 : PCB Setup - LD/OPX Assignment
Set the function of the DIOPU PCB port for DID (0) or OPX trunk (1).
➻ 10-09-01 : DTMF and Dial Tone Circuit Setup
If the system has DTMF DID trunks, be sure to reserve at least one circuit for analog trunk
DTMF reception (type 0 or 2). There must be an available receiver for each DTMF DID
trunk.
● Use the following as a guide when allocating DTMF receivers:
- In light traffic sites, allocate one DTMF receiver for every 10 devices that use them.
- In heavy traffic sites, allocate one DTMF receiver for every five devices that use them.
➻ 11-10-35 : Service Code Setup (For Administrator) - DID Mode Switching
Assign the service code to be used by a keyset or SLT user to manually change the time pat-
tern for a DID number.
➻ 14-05-01 : Trunk Groups
Put DID trunks in the same trunk group (other than group 1). If you have several types of DID
trunks, put each type in a separate trunk group.
➻ 15-07-01 : Programmable Function Keys
You can assign line or loop keys for DID trunks. Without line keys, DID calls ring line appear-
ance (CALL) keys.
In addition, assign a key for DID Mode Switching (88 + Program 22-17 table number). This
key can be used to manually change the time pattern for a DID number. The following LED
indications are used with the key:
Pattern 1 = LED off, Pattern 2 = LED on, Pattern 3 = slow flash, Pattern 4 = fast flash, Patterns
5-8 = off
➪ Aspire S: Trunk 1-8
➪ Aspire: Trunk 1-200
➻ 20-06-01 : Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
➻ 20-07-26 : Class of Service Options (Administrator Level) - DID Mode Switching
For each Class of Service, enable (1) or disable (0) an extension’s ability to manually change
the time pattern for a DID Conversion Table.
➻ 20-09-01 : Class of Service Options (Incoming Call Service) - Second Call for DID/
DISA/ DIL/ E&M
Enable (1) or disable (0) an extension’s ability to receive a second call from a DID, DISA,
DIL, or tie line caller.
➻ 20-13-23 : Class of Service Options (Supplementary Service) - Display the Reason for
Transfer
Enable (1) or disable (0) an extension’s ability to display the reason (Call Forward, Busy, No
Answer or DND) a VRS, DID, DISA, or ISDN call is being transferred to their extension.
➻ 21-01-02 : System Options for Outgoing Calls - Intercom Interdigit Time
Set the time-out interval for DID callers that don’t dial. After this interval, the DID call routes
according to Vacant Number Intercept programming.
➻ 22-01-06 : System Options for Incoming Calls - DID Ring-No-Answer Time
Set the DID Ring-No-Answer (RNA) Intercept interval (0-64800 seconds). In systems with
RNA Intercept, the DID call rings the destination extension for this interval and then rings
Intercept Ring Group.
➻ 22-02-01 : Incoming Call Trunk Setup
For each Night Service Mode, enter service type 3 when the trunk should be a DID trunk.
When the DID Call by Time Schedule feature is to be used, enter the trunk type as "8" (Mode
DID).