Filter
Top Products
SA-1110 Developer’s Manual 323
Peripheral Control Module
The following table shows the location of the flags within HSSP status register 1. The bits within
this register are read-only and do not produce interrupt requests. Note that writes to bit 7 are
ignored and reads return zero.
11.10.12 UART Register Locations
Table 11-17 shows the registers associated with the UART block and the physical addresses used to
access them.
0h 8004 0078 HSSR1 Read-Only
7 6 5 4 3 2 1 0
Reserved ROR CRE EOF TNF RNE TBY
RSY
Reset
0 0 0 0 1 0 0 0
Bits Name Description
0RSY
Receiver synchronized flag (read-only).
0 – Receiver is in hunt mode or is disabled.
1 – Receiver logic is synchronized with the incoming data (no interrupt generated).
1TBY
Transmitter busy flag (read-only).
0 – Transmitter is idle (continuous preambles) or disabled.
1 – Transmit logic is currently transmitting a frame (address, control, data, CRC, or
start/stop flag); no interrupt generated.
2 RNE
Receive FIFO not empty (read-only).
0 – Receive FIFO is empty.
1 – Receive FIFO is not empty (no interrupt generated).
3TNF
Transmit FIFO not full (read-only).
0 – TransmitFIFOisfull.
1 – Transmit FIFO is not full (no interrupt generated).
4EOF
End of frame (read-only).
0 – Current frame has not completed.
1 – The value at the bottom of the receive FIFO is the last byte of data within the frame.
5 CRE
CRC error (read-only).
0 – No CRC check errors encountered in the receipt of data.
1 – CRC calculated on the incoming data. Does not match CRC value contained within the
received frame.
6ROR
Receive FIFO overrun (read-only).
0 – Receive FIFO has not experienced an overrun.
1 – Receive logic attempted to place data into receive FIFO while it was full; the next data
value in the FIFO is the last piece of “good” data before the FIFO was overrun.
7 — Reserved.