Filter
Top Products
DES-7200 Configuration Guide Chapter 1 MPLS Configuration
1-17
DES-7200(config-mpls-router)# no ldp
router-id
Restore the default value. The system Router ID
is used as the LDP Router ID.
Configuring transport-address
By default, the LSR ID is used as the global transport address. As an option, you can choose the
main address of an interface or specify an IP address as the transport address to set up an LDP
session on the interface. There are the following two configuration methods.
Use commands to configure the transport address of an interface.
Command Function
DES-7200(config-if-type ID)# mpls ldp
transport-address { interface |
ip-address}
Configure the transport address for LDP sessions
on an interface.
DES-7200(config-if-type ID)# no mpls
ldp transport-address
Delete the configuration on the interface. By
default, the global transport address is adopted. If
no global transport address is configured, the
LSR ID is used as the transport address.
Use commands in the LDP configuration mode to globally configure a transport address for
all LDP sessions.
Command Function
DES-7200(config-mpls-router)#
transport-address {interface |
ip-address | interface-name }
Configure a global transport address for LDP
sessions.
DES-7200(config-mpls-router)# no
transport-address
Remove the global setting and restore the LSR
ID as the transport address.