Filter
Top Products
DES-7200 Configuration Guide Chapter 1 Interface Configuration
1-20
Index(dec):1 (hex):1
GigabitEthernet 0/1 is DOWN , line protocol is DOWN
Hardware is Broadcom 5464 GigabitEthernet
Interface address is: no ip address
MTU 1500 bytes, BW 1000000 Kbit
Encapsulation protocol is Bridge, loopback not set
Keepalive interval is 10 sec , set
Carrier delay is 2 sec
RXload is 1 ,Txload is 1
Queueing strategy: FIFO
Output queue 0/0, 0 drops;
Input queue 0/75, 0 drops
Switchport attributes:
interface's description:""
medium-type is copper
lastchange time:0 Day: 0 Hour: 0 Minute:13 Second
Priority is 0
admin duplex mode is AUTO, oper duplex is Unknown
admin speed is AUTO, oper speed is Unknown
flow receive control admin status is OFF,flow send control admin status
is OFF,flow receive control oper status is Unknown,flow send control oper
status is Unknown
broadcast Storm Control is OFF,multicast Storm Control is OFF,unicast Storm
Control is OFF
Port-type: trunk
Native vlan:1
Allowed vlan lists:1-4094
Active vlan lists:1, 3-4
5 minutes input rate 0 bits/sec, 0 packets/sec
5 minutes output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer, 0 dropped
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 abort
0 packets output, 0 bytes, 0 underruns , 0 dropped
0 output errors, 0 collisions, 0 interface resets
The following example shows the status of aggregate port 3.
DES-7200# show interfaces aggregateport 3:
Interface : AggreatePort 3
Description :
AdminStatus : up
OperStatus : down
Hardware : -
Mtu : 1500
LastChange : 0d:0h:0m:0s
AdminDuplex : Auto
OperDuplex : Unknown
AdminSpeed : Auto
OperSpeed : Unknown
FlowControlAdminStatus : Autonego
FlowControlOperStatus : Disabled