Filter
Top Products
DES-7200 Configuration Guide Chapter 2 RIP
Configuration
2-22
DES-7200(config)#router rip
! Specify the associated network
DES-7200(config-router)#network 192.168.15.0
DES-7200(config-router)#network 192.168.10.0
! Configure G0/1 as a passive interface
DES-7200(config-router)#passive-interface gigabitEthernet 0/1
! Enable unicast update
DES-7200(config-router)#neighbor 192.168.15.1
Verification
Display the routing table of each device (mainly the routing information on
SwitchC and SwitchE):
1. View the routing table on SwitchB, as shown below:
DES-7200#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default
Gateway of last resort is no set
C 192.168.20.0/24 is directly connected, Loopback 0
C 192.168.20.1/32 is local host.
C 192.168.15.0/24 is directly connected, GigabitEthernet 0/1
C 192.168.15.2/32 is local host.
R 192.168.60.0/24 [120/1] via 192.168.15.1, 00:15:21, GigabitEthernet 0/1
2. View the routing table on SwitchC, as shown below (the bold figures are the
routing information learned through RIP):
DES-7200#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default