Filter
Top Products
DES-7200 Configuration Guide Chapter 5 OSPF
Configuration
5-27
Step 2: Display OSPFv3 neighbors. Key point: whether the adjacencies have
been created.
SwitchA#show ipv6 ospf neighbor
OSPFv3 Process (10), 2 Neighbors, 2 is Full:
Neighbor ID Pri State Dead Time Instance ID Interface
2.2.2.2 1 Full/BDR 00:00:37 0 VLAN 100
3.3.3.3 1 Full/DR 00:00:34 0 VLAN 200
Similar information will be displayed on SwitchC.
Step 3: Display OSPFv3 routes. Key point: whether the default route is generated,
and whether the inter-area route exists
SwitchC #show ipv6 route
IPv6 routing table name is Default(0) global scope - 7 entries
Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP
I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS summary
O - OSPF intra area, OI - OSPF inter area, OE1 - OSPF external type 1, OE2
- OSPF external type 2
ON1 - OSPF NSSA external type 1, ON2 - OSPF NSSA external type 2
[*] - NOT in hardware forwarding table
OI ::/0 [110/2] via FE80::21A:A9FF:FE15:4CB9, VLAN 200
L ::1/128 via Loopback, local host
C 3001:1::/64 via VLAN 200, directly connected
L 3001:1::2/128 via VLAN 200, local host
L FE80::/10 via ::1, Null0
C FE80::/64 via VLAN 200, directly connected
L FE80::21A:A9FF:FE01:FB1F/128 via VLAN 200, local host
5.3.4 Example of OSPFv3 DR election configuration
Topological Diagram