Filter
Top Products
DES-7200 Configuration Guide Chapter 2 RIP
Configuration
2-16
! Create RIP routing process
DES-7200(config)#router rip
! Configure RIP version 2
DES-7200(config-router)#version 2
! Disable automatic route summarization
DES-7200(config-router)#no auto-summary
! Specify the associated network
DES-7200(config-router)#network 110.11.2.0
DES-7200(config-router)#network 117.102.0.0
Verification
Display the routing table of each device;
1. View routing table on Switch A, as shown below (the bold figures are the
routing information learned through RIP):
DES-7200#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default
Gateway of last resort is no set
C 110.11.2.0/24 is directly connected, GigabitEthernet 0/1
C 110.11.2.1/32 is local host.
R 117.102.0.0/16 [120/1] via 110.11.2.2, 00:00:47, GigabitEthernet 0/1
C 155.10.1.0/24 is directly connected, GigabitEthernet 0/2
C 155.10.1.1/32 is local host.
C 192.168.217.0/24 is directly connected, VLAN 1
C 192.168.217.233/32 is local host.
R 196.38.165.0/24 [120/1] via 110.11.2.3, 00:19:18, GigabitEthernet 0/1
2. View routing table on Switch B, as shown below (the bold figures are the
routing information learned through RIP):
DES-7200#show ip route
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2