Filter
Top Products
DES-7200 Configuration Guide Chapter 3 Aggregate Port
Configuration
3-4
AP traffic balancing
3.2 Configuring Aggregate
Port
3.2.1 Default
Aggregate Port
Configuration
The default AP configuration is shown in the table below.
Attribute Default value
Layer-2 AP interface None
Layer-2 AP interface None
Traffic balancing
Traffic is distributed according to the source MAC addresses
of the incoming packets.
Caution
By default, the DES-7200 series perform traffic balancing based on the
combination of the source MAC addresses and destination MAC
addresses of the incoming packets.
3.2.2 Aggregate Port
Configuration
Guide
The rates of the member ports of an AP must be the same.
L2 ports can only be join a L2 AP, and L3 ports can only join a L3 AP. L2/L3