Filter
Top Products
DES-7200 Configuration Guide Chapter 12 NFPP Configuration
12-8
Command Function
DES-7200# show nfpp arp-guard
summary
Show the arp-guard parameter settings.
DES-7200# copy running-config
startup-config
Save the configurations.
To restore the global isolated time to the default value, use the no arp-guard isolate-period
command in the nfpp configuration mode. If the isolated time has been configured on a port,
you can use the no arp-guard isolate-period command to remove the port-based isolated
time configuration in the interface configuration mode.
12.3.4 Configuring the
monitored time
If the isolated time is 0 (that is no isolation), the serviceview monitor will be performed to
auto-monitor the attacker according to the configured monitored period, providing the attacker
information in the system. If the isolated time is but not 0, the arp-guard will perform hardware
isolation towards the hosts using the serviceview monitor.
Command Function
DES-7200# configure terminal
Enter the global configuration mode.
DES-7200(config)# nfpp
Enter the nfpp configuration mode.
DES-7200(config-nfpp)# arp-guard
monitor-period seconds
Configure the monitored time, ranging
180-86400s(one day). The default value is 600s.
DES-7200(config-nfpp)# end
Return to the privileged EXEC mode.
DES-7200# show nfpp arp-guard
summary
Show the arp-guard parameter settings.
DES-7200# copy running-config
startup-config
Save the configurations.
To restore the monitored time to the default value, use the no arp-guard monitor-period
command in the nfpp configuration mode.